Unable to access web UI after setting up VM and network bridge

[Nemes_Rhadamanth]

I just created a vm to run my Blue Iris setup and Unifi controller. My VM had no network access, so I created a bridge for it. This gave my VM network access but now I can no longer access Truenas GUI and any of my other truecharts apps like nextcloud etc.

I am still able to access my shares via SMB.

I am on Truenas Scale 22.12.

I can't access gui in order to provide logs I am sorry.
Any and all help is greatly appreciated.

 

[morganL]

You need to provide detail on all networking interfaces, bridges and set-up.

 

[cap]

The same thing happened to me. I created a VM with debian last night, configured the bridge (=> https://www.truenas.com/docs/scale/scaletutorials/virtualization/accessingnasfromvm/ ) and then noticed today that I can't log in to the WebGUI.
I restored the settings of TrueNAS Scale to default and reconfigured Scale.

What do I have to take care of so that something like this doesn't happen again?

I have two physical NICs, of which I only use one NIC - Intefaces:
enp2s0: 192.168.1.10/24
enp3s0: not configured

Default route: 192.168.1.1
Nameserver (DHCP): 192.168.1.100

 

[sretalla]

Did you move the IP address to the bridge once you created it?

 

[cap]

Did you move the IP address to the bridge once you created it?

Probably. I have followed the Tutotrial. In detail I can't remember what exactly I had done.
Maybe I'll try again later. I have now backed up the config, so a restore is quick if things go wrong again.

 

[cap]

I can't get this to work. :( The instructions in the tutorial are also written unclearly from my point of view.

Edit:
Now it seems to work.
Thanks @ urza:
=> https://www.truenas.com/community/threads/vms-cant-see-host.88517/page-2#post-697216