So I did not see anyone else post an issue about this (I could have missed it). When I go to reboot my Truenas Scale system I am unable to get the system to fully start up until I interact with it via a keyboard and press the enter key. After I press the enter key on a keyboard it boots as expected.
What I have discovered:
When rebooting the system with no keyboard or monitor connected I get stuck when booting. See image 2 below
When I reboot the system with a keyboard and monitor connected it starts up fine with no issues.
Boot Environments:
image 1
What I get when I reboot the system with keyboard and monitor disconnected
image 2
System Hardware
Motherboard: MS-7D19
CPU: 11th Gen Intel(R) Core(TM) i5-11400 @ 2.60GHz
RAM: 16 GiB
Hard Drives: 3 Seagate IronWolf 2TB NAS, Boot Drive is a 1 Crucial P2 500GB 3D NAND NVMe
Network: On Board MB NIC
System Version: TrueNAS-SCALE-23.10.0.1
What I have discovered:
When rebooting the system with no keyboard or monitor connected I get stuck when booting. See image 2 below
When I reboot the system with a keyboard and monitor connected it starts up fine with no issues.
Boot Environments:
image 1
What I get when I reboot the system with keyboard and monitor disconnected
image 2
System Hardware
Motherboard: MS-7D19
CPU: 11th Gen Intel(R) Core(TM) i5-11400 @ 2.60GHz
RAM: 16 GiB
Hard Drives: 3 Seagate IronWolf 2TB NAS, Boot Drive is a 1 Crucial P2 500GB 3D NAND NVMe
Network: On Board MB NIC
System Version: TrueNAS-SCALE-23.10.0.1