TrueNas not booting after putting in HDD-s

[Muumi]

Hello!
So recently i started using freenas i only had one HDD so i installed TrueNAS on there and it booted everytime but when i added my 5 HDD it didnt want to boot and the only thing that the video output of the machine gives is:

Code:

>> FreeBSD EFI boot block
   Loader path: /boot/loader.efi
  
   Initializing module: ZFS UFS
   Load path: \EFI\BOOT\BOOTX64.EFI
   Load Device: PciRoot(0x0)/Pci(0x11, 0x0)/HD(1,GPT,034cc83f-9895-11eb-8693-448a5bbef9dc,0x28,0x82000)
   BootCurrent: 000e
   BootOrder: 000e[*] 000f 0010 0011 0012 0013 00a 0005 0004
   Probing 18 block devices...not supported
   not supported
   not supported
   not supported
   better
   not supported
   good
   not supported
   good
   not supported
   not supported
   not supported

And now its stuck there and not booting.
The HDD are attached via 3 Sata ports on mb and 3 Sata ports on a Pci-e to Sata controller.

My system details:
AMD A10-6700
Samsung 16GB DDR3 1666mhz
6 HDD-s, Boot device 256gb, Others 500gb, Raidz1
QNINE PCIe SATA Card 4 Port Marvell 88SE9215 chip

 

[Muumi]

Also it works when i pull out all the Sata cabels then it boots and i put the sata cabels back every time shows up. The first time i did it i made a smb share and put almost all of my pictures on there and then i shut down the system when i turned it on again it didnt work and now when i try the same trick again my pool isnt working.