System simply won't boot (only BMC works)

[naspcboss]

The system is brand new and I was running badblocks since a couple of days. I noticed in the morning today the system is not running. And I can't turn the host on. Please help.

System spec
RAM 2x CT16G4WFD8266
MB SUPERMICRO MBD-X11SCL-IF-O
Chassis Superchassis CSE-721TQ-250B (250W PSU)
CPU G5600
OS CORSAIR FORCE Series MP300 120GB

BMC event log says

• Timer interrupt - Interrupt type: None, Timer use at expiration: SMS/OS - Assertion
• Hard Reset - Interrupt type: None, Timer use at expiration: SMS/OS - Assertion

Currently

1. BMC light is blinking (status OK)
2. No fans running
3. Case front LAN light turns on
4. Can login to BMC via IPMI IP address
5. BMC reports the Host is currently off (duh)
6. Can't turn on the host using BMC or the physical switch on the chassis
7. No output on the display via VGA
8. No output on the iKVM/HTML
9. Watchdog timer disabled in BIOS
10. Haven't messed around with and watchdog jumpers
11. Tried clearing CMOS. Pulled battery out and shorted JBT1.
12. When I try to turn on the host via BMC I get the following error in the screenshot.

Any help is greatly appreciated.

 

[Chris Moore]

Completely disconnect all power from the system for five minutes, then reconnect power and try to power up again.

Did you do anything about the heat issue you reported here:
https://www.ixsystems.com/community...er-recommended-burn-in-test-screenshot.76702/