I put my older parts together that is amd based and I put the freenas iso onto a usb and had a blank usb to install on.
FreeNas sees all disk and seemed to install fine but when I restarted, I wanted to go into bios to make sure the freenas usb was the first to boot the computer is a stuck at the post screen. If I remove the usb and restart the computer works fine. Iv tried with two other usb sticks but same problem.
Its an Phenom 2 955 with a Gigabyte 770t-usb3 motherboard. I have a small 250g drive in there which freenas setup also detected but its only in there temporary once I know everything is working.
Im not really sure where to go from here.
FreeNas sees all disk and seemed to install fine but when I restarted, I wanted to go into bios to make sure the freenas usb was the first to boot the computer is a stuck at the post screen. If I remove the usb and restart the computer works fine. Iv tried with two other usb sticks but same problem.
Its an Phenom 2 955 with a Gigabyte 770t-usb3 motherboard. I have a small 250g drive in there which freenas setup also detected but its only in there temporary once I know everything is working.
Im not really sure where to go from here.