Hi,
Following some building work, our NAS was power cut several times and it has not taken it well...
The configuration is 4 1TB drives with a RAIDZ setup, so around 2.8TB usable in total.
On looking at the FreeNAS 11 interface, the pool was missing entirely. When trying to import this I could import the pool, but the imported pool only shows 900GB of space and when digging further... only one disk is in use!
When doing gpart show /dev/ada0 I can see 4 partitions, including the freebsd-zfs.
When running the same command on ada1, ada2 and ada3 I am getting the error "No such geom: /dev/adaX"
The other 3 disks (ada1-3) are still showing in Storage -> Disks but as 'unused'. SMART reporting doesnt show anything broken.
How should I go about importing the other 3 disks into the pool to get access to my data again?
Thanks for any advice in advanced.
Following some building work, our NAS was power cut several times and it has not taken it well...
The configuration is 4 1TB drives with a RAIDZ setup, so around 2.8TB usable in total.
On looking at the FreeNAS 11 interface, the pool was missing entirely. When trying to import this I could import the pool, but the imported pool only shows 900GB of space and when digging further... only one disk is in use!
When doing gpart show /dev/ada0 I can see 4 partitions, including the freebsd-zfs.
When running the same command on ada1, ada2 and ada3 I am getting the error "No such geom: /dev/adaX"
The other 3 disks (ada1-3) are still showing in Storage -> Disks but as 'unused'. SMART reporting doesnt show anything broken.
How should I go about importing the other 3 disks into the pool to get access to my data again?
Thanks for any advice in advanced.