Just updated my x10sl7-f to ipmi 1.92 and bios 3.0. Now I can't get temp readings for my CPU or PCH. This sucks! I tried resetting ipmi to default with ipmicfg. I ran it, it says it completed but it should have erased all my ipmi settings and it didn't.
I also tried flashing bios 3.0 again with the the JPME1 & JPME2 jumpers set to pins 2 & 3. Didn't work. The bios acts like it's flashing and then at the end it says "failed sending enable message to ME". The MB still works but I think somehow in the flash process ipmi/BMC got corrupted and it's not reporting the right temps now. Any ideas what I should do??? Any of you guys have the number of someone at supermicro that can help me out? Do you think I should try and RMA the board? Thanks.
Well well well... :)
I had this a couple of times.
First, why did you reset IPMI with ipmicfg? You can do it through the web GUI.
When i flashed to 2.2 i had this issue myself. I tried removing power to the board for a couple of minutes. No go
Resetting through Web GUI solved it.
The first time i had this issue, i had to reflash with jumpers set. Did you flash properly? I'm asking because i got several messages at the end of flashing and then it hung for quite a while, leaving me thinking it was done when it were not.
It's not done until it says finished and the DOS prompt is back.
I would trie resetting through GUI first. And then reboot/powercycle your system.
If no go... do another flash and be sure that it is finished. Error messages might be because of you flashing with them jumpers..?
RMA probably won't help you as they clearly states they do not take responability for a BIOS flash failure.
Edit: Just for the record, you need to remove power before setting them jumpers.