Hi All,
I've just upgrade my freenas from 9.3 to 9.10 2 days ago. Before upgrade, I've configure "MTU 9000" in Ethernet and stuff went fine. However, after download 9.10 and reboot. It said "No Configured Interfaces were found". So I cant access it from Lan exccept reset / reconfigure the NIC again.
After reset the NIC. check everything went fine and tried to put MUT back on. and issue reproduced.
Any one know the correct parameters for Jumbo Frame in 9.10 ?
Thanks
I've just upgrade my freenas from 9.3 to 9.10 2 days ago. Before upgrade, I've configure "MTU 9000" in Ethernet and stuff went fine. However, after download 9.10 and reboot. It said "No Configured Interfaces were found". So I cant access it from Lan exccept reset / reconfigure the NIC again.
After reset the NIC. check everything went fine and tried to put MUT back on. and issue reproduced.
Any one know the correct parameters for Jumbo Frame in 9.10 ?
Thanks