Rsync task not working?

[hot_powerz]

I am following the guide here http://doc.freenas.org/index.php/Rsync_Tasks
to configure duplication between 2 NAS.

I have a extra box "Remote Path" in my option when add a rsync task, which is not showing in the screenshot of guide.

I did configured the path in "Remote Module" in another NAS. So why should I need configure it the remote path again? Should I leave it blank?

Now my rsync tasks seems not working, Where should I check the log and trace the error?

 

[cyberjock]

I just setup rsync using the FreeNAS manual. Give section 8.11 a good read :) I've never used Rsync until two days ago and I got it working on the first try using section 8.11.

I always go straight to the manual first since it is well maintained. Typically a new FreeNAS version is released and the manual follows 3-5 days later.

 

[bollar]

The OP references that he's using 8.0.3 in a different thread, so I would suspect that's the source of his difficulty in this thread as well.

 

[cyberjock]

Just another reason to follow the forum guidelines and always post your hardware and FreeNAS version.