Rogla
Dabbler
- Joined
- Jan 24, 2012
- Messages
- 28
I have replication on several datasets and I think I have fairly good understanding of how it works.
Using on 9.10-STABLE.
But on one replication task, FreeNas deleted all snapshots on the PULL server.
This was my own fault, I had checked the new "Delete stale snapshots on remote system" option in the replication task but had longer downtime than between the snapshots/replications. So the replication fails now.
No blame on FreeNas.
Question is: How do I get the replication to work again?
Before 9.10 there was an "Initialize remote side for once" option that would be perfect in my situation.
How do I do the same thing in 9.10? Minimal steps to be done.
I don't bother about the snapshots, I'm using replication as a remote safety backup. Historical data is not of interest.
Using on 9.10-STABLE.
But on one replication task, FreeNas deleted all snapshots on the PULL server.
This was my own fault, I had checked the new "Delete stale snapshots on remote system" option in the replication task but had longer downtime than between the snapshots/replications. So the replication fails now.
No blame on FreeNas.
Question is: How do I get the replication to work again?
Before 9.10 there was an "Initialize remote side for once" option that would be perfect in my situation.
How do I do the same thing in 9.10? Minimal steps to be done.
I don't bother about the snapshots, I'm using replication as a remote safety backup. Historical data is not of interest.