Replaced sata dom bootdisk - device is too small

[nokia88]

Hi All,

On my servers running FreeNAS FreeNAS-11.3-U4.1 i replaced 1 failed SuperMicro Sata dom disk which i use as a mirrored bootdisk.
When ordering from SuperMicro i ordered the same size as the other Sata dom in the mirror, which is 32GB.

When replacing the disk in FreeNAS i get error: EZFS_BADDEV device is too small.

When checking the actual Sata dom disk size there is a very little difference. So actually FreeNAS is right but i was a bit supprised because i ordered a 32GB sata dom from SuperMicro. Maybe it's a hardware new revision? I don't know. But this size mismatch can cause problems in FreeNAS.

While searching the forum the only fix seems to re-install FreeNAS. Most posts were dated with FreeNAS version 9 so i'm wondering if there is another fix without re-installing FreeNAS?

The version i'm running is FreeNAS-11.3-U4.1
- 2 x 32GB sata dom raidz1 boot disks
- 8 x 6TB (2 pools raidz2)
- SuperMicro X9 platform
- 64GB ECC
- Intel Xeon E5-1620 v3

 

[Ericloewe]

No solution to the immediate problem, but you should definitely get a refund from Supermicro.

 

[nokia88]

SuperMicro is going to send me a new one.
In the meanwhile i installed FreeNAS on the smallest disk so my boot pool is healthy.

Thanks for the advice.