Replaced Drive do not detach

[Gunhead]

Hello

I recently replaced a failed drive, re-silvering commenced as expected but the old drive still shows up as Unavailable in the volume status window. Under Available Actions I have only the Detach button for this unavailable drive and if I press it it gives me the pop up message 'Disk detach has been successfully done'. All good so far but when I reload Volume Status tab the drive is still there. After I reboot, the drive is still there!

Is there a command line I should run to make the damn offline drive disappear?
Re silvering process is still ongoing.
One more question if I may: if I restart the system during resilvering, the process is continued from where was left or is completely restarted?

Thank you

 

[cyberjock]

Can you post the output of zpool status in CODE tags please.

Restarting during a resilvering restarts it from scratch if I remember correctly.

 

[Gunhead]

Sorry I don't know how to do the code thing. Here is what I got from zpool status command,
I hope it's not too much of a drag reading thru it in this state. I see two drives resilvering which is weird.

gptid/e3433434-33ee-11e2-bb8d-bc5ff454d153 ONLINE 0 0
0
replacing-4 DEGRADED 0 0
355
12908604135467531522 UNAVAIL 0 0
0 was /dev/gptid/e38e0277-33ee-11e2-bb8d-bc5ff454d153
gptid/be011d24-4bc3-11e3-bd96-bc5ff454d153 ONLINE 0 0
0 (resilvering)
gptid/e3e2a8e2-33ee-11e2-bb8d-bc5ff454d153 ONLINE 0 0
0
gptid/e4439651-33ee-11e2-bb8d-bc5ff454d153 ONLINE 0 0
0 (resilvering)
gptid/e4a26480-33ee-11e2-bb8d-bc5ff454d153 ONLINE 0 0
0
gptid/e506ea1e-33ee-11e2-bb8d-bc5ff454d153 ONLINE 0 0
0
gptid/e56e25d2-33ee-11e2-bb8d-bc5ff454d153 ONLINE 0 0
0
gptid/e5d22014-33ee-11e2-bb8d-bc5ff454d153 ONLINE 0 0
0
gptid/e6393856-33ee-11e2-bb8d-bc5ff454d153 ONLINE 0 0

 

[cyberjock]

its gotta be in CODE.. the formatting is very important.

Can you paste it in pastebin then?