Replaced drive didn't change partitions

[Khoomn]

I recently replaced a drive as the previous one was failing. I watched a youtube video that just basically said click the replace button and click "force" if there is data already on there. I did that and it finished resilvering but the partitions on the drive haven't changed. I am running my TrueNAS on proxmox and have directly passed through the drive to the VM. Do I have to wipe the drive and resilver it again to get the right partitions? If so how do I do it.

 

[Alecmascot]

I am running my TrueNAS on proxmox and have directly passed through the drive to the VM.

That configuration is not supported. You must pass thru the disk controller.

 

[Khoomn]

That configuration is not supported. You must pass thru the disk controller.

If I decide to pass through my HBA to truenas, would I lose all my data? I already have the drive passed through with the serial number but idk if it will recognize it when passing through the disk controller.

 

[Alecmascot]

If it is the same HBA and no hardware raid is involved you should be fine, but you do have a backup don't you ?

 

[Khoomn]

If it is the same HBA and no hardware raid is involved you should be fine, but you do have a backup don't you ?

Technically yes but they are in separate spots.