RoadHazard
Explorer
- Joined
- Nov 29, 2015
- Messages
- 83
So I've tried installing two different plug-ins (transmission and plexmediaserver) and neither one works yet. Both are stuck at roughly the same place. Clearly I don't yet understand how to properly configure a plug-in.
The install itself seems to go just fine. I get the progress thermometer, then the plug-in shows up under the 'Installed' tab on the Plugins page. And there's a new jail created on the Jails page. So far, so good.
Clicking on the newly installed plugin doesn't give my any configuration options, which seems odd. Surely both of these plug-ins have a lot of options I should set? The jails have options I can tinker with, but no guidance on what I should change if anything. Clicking the on/off switch for the plugin pauses for a few seconds before popping up the generic message 'some sort of error occurred'.
Finally, the system log starts spewing complaints that 'freenas kernel: arp: xx:xx:xx is using my ip address' which seems ominous. It stops when I uninstall the plugins. That's where I am now.
So... how many things have I done wrong?
The install itself seems to go just fine. I get the progress thermometer, then the plug-in shows up under the 'Installed' tab on the Plugins page. And there's a new jail created on the Jails page. So far, so good.
Clicking on the newly installed plugin doesn't give my any configuration options, which seems odd. Surely both of these plug-ins have a lot of options I should set? The jails have options I can tinker with, but no guidance on what I should change if anything. Clicking the on/off switch for the plugin pauses for a few seconds before popping up the generic message 'some sort of error occurred'.
Finally, the system log starts spewing complaints that 'freenas kernel: arp: xx:xx:xx is using my ip address' which seems ominous. It stops when I uninstall the plugins. That's where I am now.
So... how many things have I done wrong?