I have some servers that have PERC4/di cards built in, and they work fine with FreeNAS, allowing the FreeNAS software to see the physical drives. I recently acquired a PERC4/DC card, which I believe is the same controller but on a card instead of integrated. However I can't seem to get it configured so FreeNAS can see the drives that are attached to it.
I realize I can replace it with a straight up HBA but I'm out of them at the moment, and I have a few of these PERC4/DC cards and would like to use them if possible.
Any suggestions? Has anyone done this?
I realize I can replace it with a straight up HBA but I'm out of them at the moment, and I have a few of these PERC4/DC cards and would like to use them if possible.
Any suggestions? Has anyone done this?