Sharkbait
Cadet
- Joined
- May 18, 2015
- Messages
- 5
Just built and installed FreeNAS-9.3-STABLE-201505130355 on new Xeon 1231v3 hardware, 16GB ECC RAM. I have 3 plugins installed and started: Sickbeard, Transmission and Couchpotato. However, when I install the Plexmediaserver plugin (0.9.12.1.1079), it refuses to start in the FreeNAS GUI on the Plugins tab. I have uninstalled and reinstalled the plugin serveral times. I noticed in console I have a couple errors when the plugin is installed:
May 23 12:51:30 freenas kernel: ng_ether_ifnet_arrival_event: can't re-name node epair1b
May 23 12:51:30 freenas kernel: ng_ether_ifnet_arrival_event: can't re-name node epair1b
May 23 12:51:46 freenas notifier: WARNING: can't open config file: /usr/local/openssl/openssl.cnf
and
May 23 12:51:49 freenas manage.py: [freeadmin.navtree:625] An error occurred while unserializing from https://10.0.1.201/plugins/plexmediaserver/5/_s/treemenu: No JSON object could be decoded.
I can't start it if I go into the plex Jail console and run
service plexmediaserver start
I can start it using
service plexmediaserver onestart
but then when I reboot the FreeNAS server, the plugin is stopped again.
So I tried this:
sysrc 'plexmediaserver_enable=YES'
service plexmediaserver start
and now the plugin starts on a server reboot. The FreeNAS GUI shows Plex started on the Plugins tab but it can't be stopped now. Also There's nothing on the left side of the GUI listed for Plexmediaserver, is there supposed to be? It seems I can access it through the Plex web interface so I'm assuming all is well now. Is this normal behavior for this plugin?
May 23 12:51:30 freenas kernel: ng_ether_ifnet_arrival_event: can't re-name node epair1b
May 23 12:51:30 freenas kernel: ng_ether_ifnet_arrival_event: can't re-name node epair1b
May 23 12:51:46 freenas notifier: WARNING: can't open config file: /usr/local/openssl/openssl.cnf
and
May 23 12:51:49 freenas manage.py: [freeadmin.navtree:625] An error occurred while unserializing from https://10.0.1.201/plugins/plexmediaserver/5/_s/treemenu: No JSON object could be decoded.
I can't start it if I go into the plex Jail console and run
service plexmediaserver start
I can start it using
service plexmediaserver onestart
but then when I reboot the FreeNAS server, the plugin is stopped again.
So I tried this:
sysrc 'plexmediaserver_enable=YES'
service plexmediaserver start
and now the plugin starts on a server reboot. The FreeNAS GUI shows Plex started on the Plugins tab but it can't be stopped now. Also There's nothing on the left side of the GUI listed for Plexmediaserver, is there supposed to be? It seems I can access it through the Plex web interface so I'm assuming all is well now. Is this normal behavior for this plugin?