TrueNAS-SCALE-22.02-RC.1-2
I am trying to create a bridge for VMs to LAN. But whenever I "test" network changes I am kicked out of the GUI. After a while it usually reverts (but I have been forced to reboot a couple of times as well)
I have 4 1G ports. TrueNAS GUI, smb, nfs are all on eno1 (static .11). While my VM macvtap0 (static .21) is on eno4 (which is .120, dynamic provided by dhcp).
Furthermore: When I reboot the system, and it is back to defaults (no bridges). The VM behind macvtap0 has a static .21 ip. But .21 can no longer ping .11 (which is used for an NFS share to the VM), this fixes itself after a while... But I've observed that macvtap0 does not get an IPV4 address, only ipv6.
Well. This may be all good tomorrow when the next RC is out...
I am trying to create a bridge for VMs to LAN. But whenever I "test" network changes I am kicked out of the GUI. After a while it usually reverts (but I have been forced to reboot a couple of times as well)
I have 4 1G ports. TrueNAS GUI, smb, nfs are all on eno1 (static .11). While my VM macvtap0 (static .21) is on eno4 (which is .120, dynamic provided by dhcp).
Furthermore: When I reboot the system, and it is back to defaults (no bridges). The VM behind macvtap0 has a static .21 ip. But .21 can no longer ping .11 (which is used for an NFS share to the VM), this fixes itself after a while... But I've observed that macvtap0 does not get an IPV4 address, only ipv6.
Well. This may be all good tomorrow when the next RC is out...