Michael Attard
Cadet
- Joined
- Aug 21, 2013
- Messages
- 1
Hi all,
I am fairly new to Freenas, Had got it work with UFS but then it just stopped working once I was copying some data over to the drives.
I have 3x 1TB hard drives all WD Red, Set up as UFS and Stripe, All was going well and running smooth but then it just stopped working and got an alert saying:
WHen I try to create a new share I am not able to see any folders beyond the parent folder mnt.
If no hope of getting the drives working on freenas any other method to extract the data of it with the current RAID conf?
I am able to create a new volume with the 3 disks however I need to wipe the disks in order to do that.
Appreciate all the help one may offer.
Thanks,
M
I am fairly new to Freenas, Had got it work with UFS but then it just stopped working once I was copying some data over to the drives.
I have 3x 1TB hard drives all WD Red, Set up as UFS and Stripe, All was going well and running smooth but then it just stopped working and got an alert saying:
- WARNING: The volume DataHub (UFS) status is UNKNOWN
WHen I try to create a new share I am not able to see any folders beyond the parent folder mnt.
If no hope of getting the drives working on freenas any other method to extract the data of it with the current RAID conf?
I am able to create a new volume with the 3 disks however I need to wipe the disks in order to do that.
Appreciate all the help one may offer.
Thanks,
M
