Installation fails

[pioneer]

Dear FreeNAS users, admins and wizards,

I, finally, started to create my home NAS, run through many pros and cons and chose ZFS and hence FreeNAS.
I'm using mother board ASRosk J4205 with preinstalled processor, booting from flash drive (image FreeNAS-11.1-RELEASE.iso).
HDD 250Gb with some partitions on ext4 is in SATA slot for the installation to test, assume it's going to be re-partitioned by installer.

after grub I got error "unknown: I/O range not supported":

should I destroy partitions on the HDD or the motherboard is not supported yet?

thank you!
and Mery Christmas :)

 

[Redcoat]

Hi there, welcome to the forum!

And Merry Christmas to you, too.

maybe take a look at this thread here https://forums.freenas.org/index.php?threads/system-does-not-boot-any-more-after-update.59829/ where some install issues with your board were apparently worked through.

Good luck with your install.

 

[pioneer]

Amazing, it worked.
thank you very much!

 

[Redcoat]

That's great to hear. This forum is a wonderful resource - come back often - and use the search box up in the top right corner "to see what's out there). If you don't find anything useful, ask as you did here.