importing volume - ext2

[mbze430]

I am currently on 9.1.1

I've been searching high and low importing one of my HDD that is formatted using ext2. I have read that it will only mount/import ext2 volumes that has a Inode size of 128.

So here is my drive status

Inode count: 183074816
Inodes per group: 16384
Inode blocks per group: 512
Inode size: 128

Disk /dev/sdb1: 1500GB
Sector size (logical/physical): 512B/512B
Partition Table: loop

Number Start End Size File system Flags
1 0.00B 1500GB 1500GB ext2

So if someone can get me in the right directions on getting this drive mounted in my FreeNAS box, that'll be great!

TIA

 

[JakeHiltz]

What happens when you try to import the disk as UFS?

 

[dlavigne]

Have you tried using 9.2.0? There were some changes to the ext2fs code which I don't think made it into 9.1.1.

 

[mbze430]

What happens when you try to import the disk as UFS?

It gives me the same exact message as it did with ext2. I can't remember the message though... I have since put the drive back in to my Linux box... Since I need data from it

 

[mbze430]

Have you tried using 9.2.0? There were some changes to the ext2fs code which I don't think made it into 9.1.1.

No I have not tried 9.2 didn't even know it existed. I will give that a try as well.

 

[mbze430]

Ok this is a screen shot from 9.2.0-RC2

So I am not sure what's going on...

I get the same EXACT message from using UFS as well

For some reason /dev/ada1 doesn't show any partition...would that be the cause of it? If so, how can I fix that? Cause the drive & data are accessible in the Linux(Ubuntu) box (ext2)

[root@freenas ~]# ls -al /dev/ada*
crw-r----- 1 root operator 0x52 Dec 22 12:25 /dev/ada0
crw-r----- 1 root operator 0x54 Dec 22 12:25 /dev/ada0p1
crw-r----- 1 root operator 0x7a Dec 22 12:25 /dev/ada0p1.eli
crw-r----- 1 root operator 0x56 Dec 22 12:25 /dev/ada0p2
crw-r----- 1 root operator 0x58 Dec 22 12:25 /dev/ada1
[root@freenas ~]# gpart show /dev/ada1
gpart: No such geom: /dev/ada1.

for some reason it doesn't show a partition for ada1? Would that be the cause, if so how to fix that?

 

[cyberjock]

And you are using RC2 over the RELEASE because???

 

[mbze430]

Couldn't find 9.2 release.... I will try looking for it again. Rc2 was the only one that showed up in Google search

 

[cyberjock]

Go to www.freenas.org. It's available from there...

 

[mbze430]

ok, whelp, loaded 9.2 release... same problem. It just won't let me import or use this drive.

Same exact messages as 9.1.1 & 9.2-RC2

 

[Dusan]

Please post output of "fsck_ext2fs -p /dev/ada1".