SOLVED How to view SMART results when no errors are detected?

[spiceygas]

I just setup a new pool with brand news drives, and I plan to stress them and monitor for a few weeks to make sure no problems are detected. I'm also brand new to FreeNAS, so I apologize in advance if this sounds like an amateur question.

How do I get SMART results to be emailed to me even if no errors are detected? Here's what I've done so far:

1. Setup email under "System" and successfully delivered a test message.
2. Scheduled a SMART task for a short test to run daily.
3. In System > Alert Settings, set SMART Error warning level to "Info."

I never got an email that the test had run. Thumbnails below of how I did setup in steps #2 and #3.

Any suggestions what I'm doing wrong?

 

[garm]

You aren’t doing anything wrong. It’s set up as intended. If you want reports emailed there is a resource for that. Otherwise you can just set up a cron job to cycle through your drives with smartctl -a /dev/[drive] and print that to a file in an smb share or something.

 

[spiceygas]

If you want reports emailed there is a resource for that.

Can you point me to that resource?

 

[Jurgen Segaert]

Github repository for FreeNAS scripts, including disk burnin and rsync support

Github repository for FreeNAS scripts, including disk burnin and rsync support I am maintaining three repositories on GitHub for these purposes: Administration and reporting Disk burn-in Rsync These are all POSIX-compliant shell scripts that...

www.ixsystems.com

You're looking for the smart_report.sh script.

 

[spiceygas]

Thank you.