Robert Trevellyan
Pony Wrangler
- Joined
- May 16, 2014
- Messages
- 3,778
Could this procedure be added to the manual under section 8.1.11?
If you have a spare SATA port (or an eSATA port and a hard drive dock) you can use the GUI to replace the disks one at a time in a somewhat simpler and safer process than the manual describes for replacing a failed disk:
If you have a spare SATA port (or an eSATA port and a hard drive dock) you can use the GUI to replace the disks one at a time in a somewhat simpler and safer process than the manual describes for replacing a failed disk:
- Shut down the system.
- Install one new disk.
- Start up the system.
- Go to the Storage screen, select the pool and click the Volume Status button.
- In the Volume Status screen, select a disk and click the Replace button.
- Choose the new disk as the replacement.