How do i get pm80xx SAS HBA working in FreeNAS

[munemunk3y]

Hi all,

New here! trying to setup my first FreeNAS with a couple of NetApp disk shelves. Using "NetApp 111-00341+F2 4-Port HBA SAS PCIe Controller". When i run lspci -v i see this:

04:00.0 Serial Attached SCSI controller: PMC-Sierra Inc. Device 8001 (rev 05) Flags: bus master, fast devsel, latency 0, IRQ 17 Memory at df430000 (64-bit, non-prefetchable) Memory at df420000 (64-bit, non-prefetchable) Memory at df410000 (32-bit, non-prefetchable) Memory at df400000 (32-bit, non-prefetchable) Expansion ROM at df300000 [disabled] Capabilities: [40] Power Management version 3 Capabilities: [50] MSI: Enable- Count=1/32 Maskable- 64bit+ Capabilities: [70] Express Endpoint, MSI 00 Capabilities: [ac] MSI-X: Enable+ Count=16 Masked- Capabilities: [100] Advanced Error Reporting 05:00.0 Serial Attached SCSI controller: PMC-Sierra Inc. Device 8001 (rev 05) Flags: bus master, fast devsel, latency 0, IRQ 16 Memory at df230000 (64-bit, non-prefetchable) Memory at df220000 (64-bit, non-prefetchable) Memory at df210000 (32-bit, non-prefetchable) Memory at df200000 (32-bit, non-prefetchable) Expansion ROM at df100000 [disabled] Capabilities: [40] Power Management version 3 Capabilities: [50] MSI: Enable- Count=1/32 Maskable- 64bit+ Capabilities: [70] Express Endpoint, MSI 00 Memory at df200000 (32-bit, non-prefetchable) Expansion ROM at df100000 [disabled]

I am not seeing any drives. I should see 48 disks but i am only seeing my bootdisk / USB drive. Any pointers will be greatly appreciated.

 

[jgreco]

Please see

https://www.ixsystems.com/community...s-and-why-cant-i-use-a-raid-controller.81931/