Hi there,
I have a FreeNAS setup based around an HP g8 microserver.
It has all 4 bays populated and a micro SD for boot.
I have no experience with BSD or free BSD and have so far been managing with the GUI.
I Mainly chose to go down this route as my understanding is that if the NAS itself fails then I should be able to transplant the HDDs in to any other FreeNAS system and recover my volume?
Recently I have been getting the following error on boot:
What steps should I take?
I should point out that if it were to completely fail it would not be the end of the world as long as I could Mount the volumes in to a fresh install easy enough. (not that I know how to do this).
I have a FreeNAS setup based around an HP g8 microserver.
It has all 4 bays populated and a micro SD for boot.
I have no experience with BSD or free BSD and have so far been managing with the GUI.
I Mainly chose to go down this route as my understanding is that if the NAS itself fails then I should be able to transplant the HDDs in to any other FreeNAS system and recover my volume?
Recently I have been getting the following error on boot:
- CRITICAL: July 2, 2017, 9:17 p.m. - The boot volume state is ONLINE: One or more devices has experienced an error resulting in data corruption. Applications may be affected.
What steps should I take?
I should point out that if it were to completely fail it would not be the end of the world as long as I could Mount the volumes in to a fresh install easy enough. (not that I know how to do this).
Last edited by a moderator: