I recently started a new build (my original post: SuperChassis 847E16: MB/CPU/HDs recommendations).
I'm ready to install chassis into the rack. But when I was trying to understand how rails installation works, I accidentally installed rail on left side upside-down. Now, I can't detach it from chassis.
Per supermicro user manual I should see a locking tab when rail is fully extended. But in my case rail is not extended far enough to see it:
I'm not sure if it is because it is installed upside-down. Looking on the other side, I can say that rail stuck around that line:
I hope it is something simply resolvable. I'm sure SuperMicro engineers wouldn't design rails easily slideable upside-down and permanently stuck after that. Any advise is appreciated. Thanks!
I'm ready to install chassis into the rack. But when I was trying to understand how rails installation works, I accidentally installed rail on left side upside-down. Now, I can't detach it from chassis.
Per supermicro user manual I should see a locking tab when rail is fully extended. But in my case rail is not extended far enough to see it:
I'm not sure if it is because it is installed upside-down. Looking on the other side, I can say that rail stuck around that line:
I hope it is something simply resolvable. I'm sure SuperMicro engineers wouldn't design rails easily slideable upside-down and permanently stuck after that. Any advise is appreciated. Thanks!
Last edited: