Forgive me, I'm new to FreeNas, and just bought the components to set up a home network storage.
I installed FreeNAS 8.0.4 x64 on a USB stick through VMware on another computer, and from what I see the installation went through fine and without a hitch.
Now I plugged it into the box that will run FreeNAS, and everything boots normally. I get to the screen that has the options
Welcome to FreeNAS!
1. Boot FreeNAS [default]
2. Boot FreeNAS with ACPI Disabled
etc...
Now my problem is, after the default countdown or whenever I try to pick another option, the cursor turns a solid block up in the left hand corner of the screen, and everything locks up. I can't do anything at this point, besides forcing a power off.
I looked in the FAQ and didn't see anything that seemed similar, so again, forgive me for being a noob.
Setup :
Foxconn D270S Motherboard
Intel Atom D2700 processor
Seagate Barracuda Green 1.5 TB hd x2
4gb Crucial ram
I installed FreeNAS 8.0.4 x64 on a USB stick through VMware on another computer, and from what I see the installation went through fine and without a hitch.
Now I plugged it into the box that will run FreeNAS, and everything boots normally. I get to the screen that has the options
Welcome to FreeNAS!
1. Boot FreeNAS [default]
2. Boot FreeNAS with ACPI Disabled
etc...
Now my problem is, after the default countdown or whenever I try to pick another option, the cursor turns a solid block up in the left hand corner of the screen, and everything locks up. I can't do anything at this point, besides forcing a power off.
I looked in the FAQ and didn't see anything that seemed similar, so again, forgive me for being a noob.
Setup :
Foxconn D270S Motherboard
Intel Atom D2700 processor
Seagate Barracuda Green 1.5 TB hd x2
4gb Crucial ram