My asrock c2550d4i stopped working. It failed to respond after a night running, so i used the IPMI to check it out.
This is a selfbuild device. In use since about october 2015. In most cases the motherboard should die with a powerup. Mine died in a running situation.
This was the result:
According the cpu sensor it was on fire:
(strange that this management software not react on such strange values?)
The motherboard fails to boot now. Hard drives are spinning. No (VGA) output.
Only the IPMI Management interface works.
I hope some know solutions for the following questions:
* I am missing the 3, 5 and 12 volts values. Is this normal in a standby situation? With other words, i can rule out the PSU?
* Is there a solution for this issue? Just replacing it with the same revision is asking for troubles in the future.
* How do ik know/prove i get a fixed motherboard/cpu