Hello,
I have been using FreeNAS since version 10.0 so I'm rather new at it.
I am running a Supermicro X9SCL board with a Xeon E-1270 v2.
I have also a PCIe SATA extension card for two extra SATA ports. The card has a Marvell 88SE9128 chipset.
As you can see it is recognized by the system, but since updating to TrueNAS 12.0, devices attached to it are not.
It worked fine on 11.3, but as soon as I booted 12.0 after the upgraded, the drives plugged into the card had gone.
I have checked that the drives are indeed working by plugging them into another SATA port directly on the board.
Looks like something is broken on 12.0 with my particular setup, although I'm open to any suggestion to try to find the issue.
Thank you
I have been using FreeNAS since version 10.0 so I'm rather new at it.
I am running a Supermicro X9SCL board with a Xeon E-1270 v2.
I have also a PCIe SATA extension card for two extra SATA ports. The card has a Marvell 88SE9128 chipset.
Code:
ahci0@pci0:1:0:0: class=0x010601 card=0x91281b4b chip=0x91281b4b rev=0x20 hdr=0x00 vendor = 'Marvell Technology Group Ltd.' device = '88SE9128 PCIe SATA 6 Gb/s RAID controller' class = mass storage subclass = SATA
As you can see it is recognized by the system, but since updating to TrueNAS 12.0, devices attached to it are not.
It worked fine on 11.3, but as soon as I booted 12.0 after the upgraded, the drives plugged into the card had gone.
I have checked that the drives are indeed working by plugging them into another SATA port directly on the board.
Looks like something is broken on 12.0 with my particular setup, although I'm open to any suggestion to try to find the issue.
Thank you