tonyp1983
Dabbler
- Joined
- Feb 17, 2015
- Messages
- 31
I decided to upgrade from 9.3.1 to 9.10 today after doing some backups first. :)
The upgrade in WebGUI seemed to go fine and my box rebooted to complete the process but goes into a continuous boot loop. Everything goes fine, devices are recognised, ZFS storage is imported with no errors shown, the network is brought up and then I see a message about vbox (which I don't run but have done previously) then a message stating 'starting rpcbind' at which point the system reboots.
I've switched back to 9.3.1 now so that I have a working system but would like to try and figure out what the issue might be but my searches have drawn a blank.
Any suggestions/advice gratefully accepted.
The upgrade in WebGUI seemed to go fine and my box rebooted to complete the process but goes into a continuous boot loop. Everything goes fine, devices are recognised, ZFS storage is imported with no errors shown, the network is brought up and then I see a message about vbox (which I don't run but have done previously) then a message stating 'starting rpcbind' at which point the system reboots.
I've switched back to 9.3.1 now so that I have a working system but would like to try and figure out what the issue might be but my searches have drawn a blank.
Any suggestions/advice gratefully accepted.