This is my first time installing TrueNAS and the installation and file server setup went well. I've created SMB and NFS shares that are working fine. My problem is that while I can *install* apps, I can't start any of them. They all get hung in the "Deploying" state. So far I've tried emby, home-assistant, and node-red all with the same results.
My system is a low-end home-built file server that I've been running XigmaNAS on for six years. I just recently decided to switch to TrueNAS Scale explicitly because of the app support but that hasn't been kind to me. :)
Running dmesg shows a constant stream of messages like this:
IPVS: rr: UDP 172.17.0.10:53 - no destination available
Googling for this symptom and message turned up a lot of threads but they all seemed to be app-specific or were otherwise not relevant to my situation. I suspect I missed a step in the installation of TrueNAS Scale but I can't figure out what it was. Any suggestions?
My hardware setup follows.
AMD A8-7600
16 GB RAM
One 256 GB SSD for the OS
Four 4 TB Western Digital drives setup as two pools of two drives each
Single 1Gpbs NIC
Home network is 192.168.1.*
Router is OPNSense running on a Protectli Vault
No VLANs or other network complexity
Yeah, this isn't spectacular hardware but it was rock-solid with XigmaNAS and has been sufficient for my purposes.
My system is a low-end home-built file server that I've been running XigmaNAS on for six years. I just recently decided to switch to TrueNAS Scale explicitly because of the app support but that hasn't been kind to me. :)
Running dmesg shows a constant stream of messages like this:
IPVS: rr: UDP 172.17.0.10:53 - no destination available
Googling for this symptom and message turned up a lot of threads but they all seemed to be app-specific or were otherwise not relevant to my situation. I suspect I missed a step in the installation of TrueNAS Scale but I can't figure out what it was. Any suggestions?
My hardware setup follows.
AMD A8-7600
16 GB RAM
One 256 GB SSD for the OS
Four 4 TB Western Digital drives setup as two pools of two drives each
Single 1Gpbs NIC
Home network is 192.168.1.*
Router is OPNSense running on a Protectli Vault
No VLANs or other network complexity
Yeah, this isn't spectacular hardware but it was rock-solid with XigmaNAS and has been sufficient for my purposes.