Hello,
long story short: if I go to status, I can see "/dev/gptid/ee323142-0d57-11ec-9b04-000c29fc4700" which says OFFLINE. If I press replace with da8 selected (the new disk is apparently also da8), even with Force selected, nothing happens, the button does not react. I can only close the window.
Longer explanation:
My da8 (old Seagate) disk died. Today replacement arrived (WD Red), and honestly, I didn't read any instructions prior, but I simply pulled the disk out, put the new one in and went into Pool Status. Whatever I tried at that moment, did not work. Obviously, now that I am reading about how to do it, correctly. I was kinda used to the process from my Synology, that I just did the same.
Is there a way to replace the drive now or do I have to put the old drive back in, with hope that it even gets recognized??
Thanks
long story short: if I go to status, I can see "/dev/gptid/ee323142-0d57-11ec-9b04-000c29fc4700" which says OFFLINE. If I press replace with da8 selected (the new disk is apparently also da8), even with Force selected, nothing happens, the button does not react. I can only close the window.
Longer explanation:
My da8 (old Seagate) disk died. Today replacement arrived (WD Red), and honestly, I didn't read any instructions prior, but I simply pulled the disk out, put the new one in and went into Pool Status. Whatever I tried at that moment, did not work. Obviously, now that I am reading about how to do it, correctly. I was kinda used to the process from my Synology, that I just did the same.
Is there a way to replace the drive now or do I have to put the old drive back in, with hope that it even gets recognized??
Thanks