can't click or enable "start on boot"

Status
Not open for further replies.

CarlosDE

Cadet
Joined
Oct 10, 2017
Messages
2
This is a new install of FreeNAS 11 on an Asus motherboard I followed the instructions for setting up a UPS for FreeNAS. Part of those instructions is click the "start on boot" but when I click on "start on boot" nothing happens. Any ideas to resolve this? I can start the UPS service, but I can't get it to "start on boot"

The exact same thing happens with SSH service as well.

Any advice?

Thanks,
Carlos
 

SweetAndLow

Sweet'NASty
Joined
Nov 6, 2013
Messages
6,421
File a bug
 

CarlosDE

Cadet
Joined
Oct 10, 2017
Messages
2
Earlier today I have discovered this is an interface/Browser issue. It fails in Internet Explorer, however it works fine with Firefox, I will update the bug. (Chrome and Edge do not work at all.) I was able to test this with Windows 10 and 2012 R2 using IE and it did not work. It did work from Firefox on Ubuntu.
 

SweetAndLow

Sweet'NASty
Joined
Nov 6, 2013
Messages
6,421
Earlier today I have discovered this is an interface/Browser issue. It fails in Internet Explorer, however it works fine with Firefox, I will update the bug. (Chrome and Edge do not work at all.) I was able to test this with Windows 10 and 2012 R2 using IE and it did not work. It did work from Firefox on Ubuntu.
Make sure to include version for all those browser. Some of them get updated very frequently.
 
Status
Not open for further replies.
Top