ziggo0
Cadet
- Joined
- Apr 2, 2017
- Messages
- 1
Hello TrueNAS Forum,
I finally got my Management VLAN setup and going. Currently running the latest TrueNAS Core 13.0-U5 with 2 seperate NICs. Intel 1gb for Management, Mellanox ConnectX-3 10gb for data. Intel/em0 is 10.0.10.3 and Mellanox/mlxen0 is 10.0.1.250, DHCP. When I go to System -> General to set the Web Interface IPv4 Address - the list is empty. It shows this:
Same for Services -> NFS
However in Services -> SMB - both IP/Interfaces show up.
I'm not positive but I think I read somewhere that static DHCP addresses do not show up? Here is another issue...when I go to Network -> Interfaces, when I try to change it from DHCP to a static IP I uncheck DHCP - right? I hit apply, let it test - after the test it's still on DHCP. Doesn't matter which interface I do it to. My previous NAS was FreeBSD for so many years I can't count - not afraid of going in and editing files manually but I'm really trying to use this as an appliance. Thanks for reading & any advice
I finally got my Management VLAN setup and going. Currently running the latest TrueNAS Core 13.0-U5 with 2 seperate NICs. Intel 1gb for Management, Mellanox ConnectX-3 10gb for data. Intel/em0 is 10.0.10.3 and Mellanox/mlxen0 is 10.0.1.250, DHCP. When I go to System -> General to set the Web Interface IPv4 Address - the list is empty. It shows this:
Same for Services -> NFS
However in Services -> SMB - both IP/Interfaces show up.
I'm not positive but I think I read somewhere that static DHCP addresses do not show up? Here is another issue...when I go to Network -> Interfaces, when I try to change it from DHCP to a static IP I uncheck DHCP - right? I hit apply, let it test - after the test it's still on DHCP. Doesn't matter which interface I do it to. My previous NAS was FreeBSD for so many years I can't count - not afraid of going in and editing files manually but I'm really trying to use this as an appliance. Thanks for reading & any advice
