mundodisco
Cadet
- Joined
- Mar 8, 2014
- Messages
- 2
Hi folks!
I have managed to install aMule in a custom jail, and it is working perfectly (I connect to it through aMule Remote GUI). The problem is that I don't know how to make the application (or service, not sure) "amuled" to start automatically each time the jail runs. If I restart the NAS, I have to go into the jail, and in the command-line (of that jail), write:
amuled -f
After that, and until I restart NAS (or the jail), everything runs just fine.
I have read something about modifying the file "rc.conf", but I am pretty sure I am missing some part.
Thank you very much in advance!
Kind regards,
GABRIEL
from Buenos Aires, Argentina
I have managed to install aMule in a custom jail, and it is working perfectly (I connect to it through aMule Remote GUI). The problem is that I don't know how to make the application (or service, not sure) "amuled" to start automatically each time the jail runs. If I restart the NAS, I have to go into the jail, and in the command-line (of that jail), write:
amuled -f
After that, and until I restart NAS (or the jail), everything runs just fine.
I have read something about modifying the file "rc.conf", but I am pretty sure I am missing some part.
Thank you very much in advance!
Kind regards,
GABRIEL
from Buenos Aires, Argentina