rrosenwald
Dabbler
- Joined
- Mar 17, 2013
- Messages
- 21
I am very novice but I had 9.1 working perfectly for the last year and a half. I just upgraded to 9.3 and during the reboot I get to a point where the screen says:
ums:0 5 buttons and [XYZ] coordinates ID=1
and after this there are continual rows of periods scrolling on the screen. I have a PS/2 mouse and keyboard plugged into a PS/2 to USB adapter which was working perfectly under 9.1. If I unplug the USB adapter 0the periods stop and I get a couple of messages that end in (disconnected). When I plug it back in I get:
ukbd0: <EP1> on usbus0
kbd2 at ukbd0
ums0: <EP2> on usb0
ums:0 5 buttons and [XYZ] coordinates ID=1
and again and after this there are continual rows of periods scrolling on the screen.
Any help would be much appreciated
ums:0 5 buttons and [XYZ] coordinates ID=1
and after this there are continual rows of periods scrolling on the screen. I have a PS/2 mouse and keyboard plugged into a PS/2 to USB adapter which was working perfectly under 9.1. If I unplug the USB adapter 0the periods stop and I get a couple of messages that end in (disconnected). When I plug it back in I get:
ukbd0: <EP1> on usbus0
kbd2 at ukbd0
ums0: <EP2> on usb0
ums:0 5 buttons and [XYZ] coordinates ID=1
and again and after this there are continual rows of periods scrolling on the screen.
Any help would be much appreciated