After new install of FreeNAS , will I have to flash the LSI card again

[avalon60]

About a month a go I got this:
LSI Mega 9240-8i SAS SATA LSI00200 8-port Server RAID Controller Card IBM M1015
and I flashed to IT mode using the P20 version.

Since then I have had to do a fresh install of FreeNAS 9.3 and when I try to upload backups from say 3 weeks ago, I get an error saying Firmware version 20 does not match driver version 16 for /dev/mps0.

I am guessing I need to flash the card again.

If that be the case, can someone point me in right direction of how to flash the card with it already installed.
I have the p20 firmware files etc, but I have forgotten how it should be done.
I have looked on the LSI card thread but can't find what I am looking for.

 

[jgreco]

If you had to do a fresh install, is there some reason you didn't install 9.10? At this point I think that FreeNAS has been using Phase 20 firmware for almost a year.

 

[avalon60]

I am trying to install 9.10 now, using an earlier version from the current latest, which does not finish loading. When I tried updating to the latest version it was doing almost the same thing, and I created a bug report 1650 for it.
I'll see how the earlier version loads up.

The reason I was going to use 9.3 was so I could upload the latest backup file.