A general system error occurred: Invalid fault

Status
Not open for further replies.

saxman8837

Cadet
Joined
Mar 21, 2013
Messages
1
I just got the FreeNas up and running, and I was able to add it as a Datastore, but when I try to convert machine and go through the steps I get this error. "A general system error occurred: Invalid fault"

Any one have any ideas ?
 

joeschmuck

Old Man
Moderator
Joined
May 28, 2011
Messages
10,996
Forum Rule #3

3. When you start a new thread you MUST write a subject that accurately describes the content.

Including the following information in your thread will increase the chance you will get an answer:


  1. FreeNAS version and platform (32 or 64 bit).
  2. General hardware information (CPU, RAM, Motherboard model, etc.).
  3. Specific hardware information (Network card chipset, Raid controller chipset, etc.).
  4. DMESG output or copy of specific error message.
  5. IFCONFIG output if you are asking about a NIC or networking problem.
  6. PCICONF -lv output if you are asking about MotherBoard and / or PCI card problems.
  7. Code snippets, logs, config files and quotes should be enclosed in the appropriate bbcode tags.
  8. To provide you with accurate answers we need this information and it will also help others to find your posts when they are searching for similar information.

http://forums.freenas.org/showthread.php?1-Forum-Rules
 
Status
Not open for further replies.
Top