vasiliinorris
Cadet
- Joined
- Sep 23, 2022
- Messages
- 2
I've got a server running Lubuntu and I have VMWare Workstation installed there.
I've installed TrueNAS Core as a VM and using Virtual Network Editor specified that 10 GBit NIC should be used for bridging.
Running ethtool on host:
Running ifconfig in VM:
I'm using outdated RAID cards that don't properly passthrough to Lubuntu if using ESXi (+ these cards are not supported by ESXi, so just passing the disks to VM is also a no-go), and the disks on these RAID cards use ext4 so I can't just install TrueNAS bare metal. I will not reformat them to ZFS because it will take very long time.
That's why I'm stuck with Type 2 Hypervisor and need to understand why my VM only uses 1 GBit instead of 10 GBit.\
Any help appreciated.
I've installed TrueNAS Core as a VM and using Virtual Network Editor specified that 10 GBit NIC should be used for bridging.
Running ethtool on host:
Code:
lubuntu@lubuntu:~$ sudo ethtool enp1s0 Settings for enp1s0: Supported ports: [ TP ] Supported link modes: 100baseT/Full 1000baseT/Full 10000baseT/Full 2500baseT/Full 5000baseT/Full Supported pause frame use: Symmetric Receive-only Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: 100baseT/Full 1000baseT/Full 10000baseT/Full 2500baseT/Full 5000baseT/Full Advertised pause frame use: No Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Speed: 10000Mb/s Duplex: Full Auto-negotiation: on Port: Twisted Pair PHYAD: 0 Transceiver: internal MDI-X: Unknown Supports Wake-on: pg Wake-on: g Current message level: 0x00000005 (5) drv link Link detected: yes
Running ifconfig in VM:
Code:
root@truenas[~]# ifconfig em0: flags=8863<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500 description: em0 options=481009b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,VLAN_HWFILTER,NOMAP> ether 00:0c:29:34:ec:d7 inet 10.1.0.41 netmask 0xffffff00 broadcast 10.1.0.255 media: Ethernet autoselect (1000baseT <full-duplex>) status: active nd6 options=9<PERFORMNUD,IFDISABLED>
I'm using outdated RAID cards that don't properly passthrough to Lubuntu if using ESXi (+ these cards are not supported by ESXi, so just passing the disks to VM is also a no-go), and the disks on these RAID cards use ext4 so I can't just install TrueNAS bare metal. I will not reformat them to ZFS because it will take very long time.
That's why I'm stuck with Type 2 Hypervisor and need to understand why my VM only uses 1 GBit instead of 10 GBit.\
Any help appreciated.