smartctl 7.2 2021-09-14 r5236 [FreeBSD 13.1-RELEASE-p7 amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Western Digital Red Device Model: WDC WD40EFRX-68N32N0 Serial Number: WD-WCC7K0AA49D4 LU WWN Device Id: 5 0014ee 20e9310a6 Firmware Version: 82.00A82 User Capacity: 4,000,787,030,016 bytes [4.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 3.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-3 T13/2161-D revision 5 SATA Version is: SATA 3.1, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Sat Dec 9 11:08:50 2023 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: (44820) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 475) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x303d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x002f 200 200 051 Pre-fail Always - 0 3 Spin_Up_Time 0x0027 165 165 021 Pre-fail Always - 6708 4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 165 5 Reallocated_Sector_Ct 0x0033 200 200 140 Pre-fail Always - 0 7 Seek_Error_Rate 0x002e 100 253 000 Old_age Always - 0 9 Power_On_Hours 0x0032 024 024 000 Old_age Always - 55989 10 Spin_Retry_Count 0x0032 100 100 000 Old_age Always - 0 11 Calibration_Retry_Count 0x0032 100 100 000 Old_age Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 162 192 Power-Off_Retract_Count 0x0032 200 200 000 Old_age Always - 84 193 Load_Cycle_Count 0x0032 200 200 000 Old_age Always - 201 194 Temperature_Celsius 0x0022 127 105 000 Old_age Always - 23 196 Reallocated_Event_Count 0x0032 200 200 000 Old_age Always - 0 197 Current_Pending_Sector 0x0032 200 200 000 Old_age Always - 1 198 Offline_Uncorrectable 0x0030 100 253 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0 200 Multi_Zone_Error_Rate 0x0008 100 253 000 Old_age Offline - 0 SMART Error Log Version: 1 ATA Error Count: 2 CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 2 occurred at disk power-on lifetime: 55952 hours (2331 days + 8 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 80 20 7a 58 e8 Error: UNC 128 sectors at LBA = 0x08587a20 = 140016160 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 80 18 7a 58 e8 00 7d+12:11:31.101 READ DMA c8 00 80 18 7a 58 e8 00 7d+12:11:27.372 READ DMA c8 00 80 10 79 58 e8 00 7d+12:11:27.371 READ DMA c8 00 80 08 78 58 e8 00 7d+12:11:27.370 READ DMA c8 00 80 00 77 58 e8 00 7d+12:11:27.369 READ DMA Error 1 occurred at disk power-on lifetime: 55952 hours (2331 days + 8 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 80 20 7a 58 e8 Error: UNC 128 sectors at LBA = 0x08587a20 = 140016160 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 80 18 7a 58 e8 00 7d+12:11:27.372 READ DMA c8 00 80 10 79 58 e8 00 7d+12:11:27.371 READ DMA c8 00 80 08 78 58 e8 00 7d+12:11:27.370 READ DMA c8 00 80 00 77 58 e8 00 7d+12:11:27.369 READ DMA c8 00 80 f8 75 58 e8 00 7d+12:11:27.365 READ DMA SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 55231 - # 2 Short offline Completed without error 00% 55229 - # 3 Short offline Completed without error 00% 55228 - # 4 Short offline Completed without error 00% 55227 - # 5 Short offline Completed without error 00% 55226 - # 6 Short offline Completed without error 00% 55225 - # 7 Short offline Completed without error 00% 55224 - # 8 Short offline Completed without error 00% 55223 - # 9 Short offline Completed without error 00% 55222 - #10 Short offline Completed without error 00% 55221 - #11 Short offline Completed without error 00% 55220 - #12 Short offline Completed without error 00% 55219 - #13 Short offline Completed without error 00% 55218 - #14 Short offline Completed without error 00% 55217 - #15 Short offline Completed without error 00% 55216 - #16 Short offline Completed without error 00% 55215 - #17 Short offline Completed without error 00% 55214 - #18 Short offline Completed without error 00% 55213 - #19 Short offline Completed without error 00% 55212 - #20 Short offline Completed without error 00% 55212 - #21 Short offline Completed without error 00% 55210 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.