--- hdparm10T.txt	2023-05-05 14:13:58.323395781 +1000
+++ hdparm14T.txt	2023-05-05 14:13:50.835490120 +1000
@@ -1,15 +1,15 @@
 
-/dev/sdm:
+/dev/sdl:
 
 ATA device, with non-removable media
-	Model Number:       ST10000VN0004-1ZD101                    
-	Serial Number:      ZA2APHKA
-	Firmware Revision:  SC60    
-	Transport:          Serial, ATA8-AST, SATA 1.0a, SATA II Extensions, SATA Rev 2.5, SATA Rev 2.6, SATA Rev 3.0
+	Model Number:       ST14000NM001G                           
+	Serial Number:      ZLW1XSWP
+	Firmware Revision:  SN03    
+	Transport:          Serial, SATA Rev 3.0
 Standards:
-	Used: unknown (minor revision code 0x006d) 
-	Supported: 10 9 8 7 6 5 
-	Likely used: 10
+	Used: unknown (minor revision code 0x0029) 
+	Supported: 8 7 6 5 
+	Likely used: 8
 Configuration:
 	Logical		max	current
 	cylinders	16383	16383
@@ -18,14 +18,11 @@
 	--
 	CHS current addressable sectors:    16514064
 	LBA    user addressable sectors:   268435455
-	LBA48  user addressable sectors: 19532873728
-	Logical  Sector size:                   512 bytes
-	Physical Sector size:                  4096 bytes
-	Logical Sector-0 offset:                  0 bytes
-	device size with M = 1024*1024:     9537536 MBytes
-	device size with M = 1000*1000:    10000831 MBytes (10000 GB)
+	LBA48  user addressable sectors: 27344764928
+	Logical/Physical Sector size:           512 bytes
+	device size with M = 1024*1024:    13351936 MBytes
+	device size with M = 1000*1000:    14000519 MBytes (14000 GB)
 	cache/buffer size  = unknown
-	Form Factor: 3.5 inch
 	Nominal Media Rotation Rate: 7200
 Capabilities:
 	LBA, IORDY(can be disabled)
@@ -44,41 +41,34 @@
 	   *	Power Management feature set
 	   *	Write cache
 	   *	Look-ahead
+	   *	Host Protected Area feature set
 	   *	WRITE_BUFFER command
 	   *	READ_BUFFER command
 	   *	DOWNLOAD_MICROCODE
-	    	Power-Up In Standby feature set
-	   *	SET_FEATURES required to spinup after power up
 	    	SET_MAX security extension
 	   *	48-bit Address feature set
+	   *	Device Configuration Overlay feature set
 	   *	Mandatory FLUSH_CACHE
 	   *	FLUSH_CACHE_EXT
 	   *	SMART error logging
 	   *	SMART self-test
-	   *	Media Card Pass-Through
 	   *	General Purpose Logging feature set
 	   *	WRITE_{DMA|MULTIPLE}_FUA_EXT
 	   *	64-bit World wide name
-	   *	IDLE_IMMEDIATE with UNLOAD
 	    	Write-Read-Verify feature set
 	   *	WRITE_UNCORRECTABLE_EXT command
 	   *	{READ,WRITE}_DMA_EXT_GPL commands
 	   *	Segmented DOWNLOAD_MICROCODE
-	    	unknown 119[6]
+	   *	unknown 119[6]
 	   *	unknown 119[7]
-	    	unknown 119[8]
 	   *	Gen1 signaling speed (1.5Gb/s)
 	   *	Gen2 signaling speed (3.0Gb/s)
 	   *	Gen3 signaling speed (6.0Gb/s)
 	   *	Native Command Queueing (NCQ)
 	   *	Phy event counters
-	   *	Idle-Unload when NCQ is active
 	   *	READ_LOG_DMA_EXT equivalent to READ_LOG_EXT
-	   *	DMA Setup Auto-Activate optimization
 	    	Device-initiated interface power management
-	   *	Software settings preservation
-	    	unknown 78[7]
-	    	unknown 78[11]
+	    	Software settings preservation
 	   *	SMART Command Transport (SCT) feature set
 	   *	SCT Write Same (AC2)
 	   *	SCT Error Recovery Control (AC3)
@@ -86,11 +76,6 @@
 	   *	SCT Data Tables (AC5)
 	    	unknown 206[7]
 	    	unknown 206[12] (vendor specific)
-	    	unknown 206[14] (vendor specific)
-	   *	SANITIZE_ANTIFREEZE_LOCK_EXT command
-	   *	SANITIZE feature set
-	   *	OVERWRITE_EXT command
-	   *	Extended number of user addressable sectors 
 Security: 
 	Master password revision code = 65534
 		supported
@@ -99,9 +84,9 @@
 	not	frozen
 	not	expired: security count
 		supported: enhanced erase
-	842min for SECURITY ERASE UNIT. 842min for ENHANCED SECURITY ERASE UNIT.
-Logical Unit WWN Device Identifier: 5000c500b5317fd5
+	210min for SECURITY ERASE UNIT. 210min for ENHANCED SECURITY ERASE UNIT.
+Logical Unit WWN Device Identifier: 5000c500c74e627d
 	NAA		: 5
 	IEEE OUI	: 000c50
-	Unique ID	: 0b5317fd5
-Checksum: correct
+	Unique ID	: 0c74e627d
+Integrity word not set (found 0x0000, expected 0xeea5)
