Best to do this with just a single H200 to avoid incorrectly flashing the wrong device... Should always get the "SAS Address" First and write it down; just to be safe: Command: sas2flsh -listall If you need to first update the Dell Firmware & BIOS *** May not be needed if the Dell is already at v7x 1) Change to "Dell_V7" Directory Command: CD H200\Dell_V7 2) Put the card into "Advanced Mode" and Erase Existing Flash: Command: sas2flsh -o -e 6 3) Apply Firmware and BIOS: Command: Command: sas2flsh -o -f 6GBPSAS.FW -b mptsas2.rom Apply the LSI "P7" Firmware & BIOS 1) Change to "LSI_P7" Directory Command: CD H200\LSI_P7 2) Put the card into "Advanced Mode" and Erase Existing Flash: *** If you already ran this previously without rebooting; then it can be skipped Command: sas2flsh -o -e 6 3) Apply Firmware and BIOS: Command: Command: sas2flsh -o -f 2118it.bin -b mptsas2.rom Apply the LSI "P20" Firmware & BIOS 1) Change to "LSI_P20" Directory Command: CD H200\LSI_P20 2) Put the card into "Advanced Mode" and Erase Existing Flash: *** If you already ran this previously without rebooting; then it can be skipped Command: sas2flsh -o -e 6 3) Apply Firmware and BIOS: Command: Command: sas2flsh -o -f 2118it.bin -b mptsas2.rom When done, simply reboot. To verify: Command: sas2flsh -listall