smartctl 7.2 2021-09-14 r5236 [FreeBSD 13.1-RELEASE-p2 amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Western Digital Gold Device Model: WDC WD4003FRYZ-01F0DB0 Serial Number: V3GJVKWF LU WWN Device Id: 5 000cca 0c4c7a9b4 Firmware Version: 01.01H01 User Capacity: 4,000,787,030,016 bytes [4.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4 SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Thu Jan 12 15:41:24 2023 PST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 87) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 503) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 100 100 016 Pre-fail Always - 0 2 Throughput_Performance 0x0005 130 130 054 Pre-fail Offline - 100 3 Spin_Up_Time 0x0007 139 139 024 Pre-fail Always - 305 (Average 304) 4 Start_Stop_Count 0x0012 100 100 000 Old_age Always - 55 5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 0 7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0 8 Seek_Time_Performance 0x0005 128 128 020 Pre-fail Offline - 18 9 Power_On_Hours 0x0012 100 100 000 Old_age Always - 2226 10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 55 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 146 193 Load_Cycle_Count 0x0012 100 100 000 Old_age Always - 146 194 Temperature_Celsius 0x0002 150 150 000 Old_age Always - 40 (Min/Max 19/46) 196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 0 197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 24 SMART Error Log Version: 1 ATA Error Count: 24 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 24 occurred at disk power-on lifetime: 1874 hours (78 days + 2 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 00 00 00 00 00 Error: ICRC, ABRT at LBA = 0x00000000 = 0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 40 e8 78 3e e1 40 08 01:59:10.917 READ FPDMA QUEUED 60 40 e0 38 3e e1 40 08 01:59:10.914 READ FPDMA QUEUED 60 40 d8 f8 3d e1 40 08 01:59:10.914 READ FPDMA QUEUED 60 40 d0 b8 3d e1 40 08 01:59:10.913 READ FPDMA QUEUED 60 40 c8 78 3d e1 40 08 01:59:10.913 READ FPDMA QUEUED Error 23 occurred at disk power-on lifetime: 1874 hours (78 days + 2 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 00 00 00 00 00 Error: ICRC, ABRT at LBA = 0x00000000 = 0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 40 60 c0 31 e1 40 08 01:59:10.901 READ FPDMA QUEUED 60 80 68 00 32 e1 40 08 01:59:10.900 READ FPDMA QUEUED 60 40 58 80 31 e1 40 08 01:59:10.900 READ FPDMA QUEUED 60 40 50 40 31 e1 40 08 01:59:10.900 READ FPDMA QUEUED 60 c0 48 80 30 e1 40 08 01:59:10.899 READ FPDMA QUEUED Error 22 occurred at disk power-on lifetime: 1874 hours (78 days + 2 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 00 00 00 00 00 Error: ICRC, ABRT at LBA = 0x00000000 = 0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 40 50 e0 25 e0 40 08 01:59:10.629 READ FPDMA QUEUED 60 40 48 a0 25 e0 40 08 01:59:10.628 READ FPDMA QUEUED 60 40 40 60 25 e0 40 08 01:59:10.628 READ FPDMA QUEUED 60 40 38 20 25 e0 40 08 01:59:10.628 READ FPDMA QUEUED 60 40 30 e0 23 e0 40 08 01:59:10.628 READ FPDMA QUEUED Error 21 occurred at disk power-on lifetime: 1874 hours (78 days + 2 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 00 00 00 00 00 Error: ICRC, ABRT at LBA = 0x00000000 = 0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 00 20 df df 40 08 01:59:10.560 READ FPDMA QUEUED 60 40 10 20 e7 df 40 08 01:59:10.557 READ FPDMA QUEUED 60 00 08 20 e1 df 40 08 01:59:10.557 READ FPDMA QUEUED 60 08 f8 e0 64 21 40 08 01:59:10.551 READ FPDMA QUEUED 60 00 f0 20 d7 df 40 08 01:59:10.551 READ FPDMA QUEUED Error 20 occurred at disk power-on lifetime: 1874 hours (78 days + 2 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 00 00 00 00 00 Error: ICRC, ABRT at LBA = 0x00000000 = 0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 80 28 a8 30 de 40 08 01:59:10.063 READ FPDMA QUEUED 60 c0 38 e8 36 de 40 08 01:59:10.062 READ FPDMA QUEUED 60 80 30 e8 33 de 40 08 01:59:10.060 READ FPDMA QUEUED 60 80 20 68 2d de 40 08 01:59:10.059 READ FPDMA QUEUED 60 00 18 e8 2a de 40 08 01:59:10.059 READ FPDMA QUEUED SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 2210 - # 2 Short offline Completed without error 00% 2163 - # 3 Short offline Completed without error 00% 2139 - # 4 Short offline Completed without error 00% 2115 - # 5 Short offline Completed without error 00% 2091 - # 6 Short offline Completed without error 00% 2067 - # 7 Short offline Completed without error 00% 2007 - # 8 Short offline Completed without error 00% 1983 - # 9 Short offline Completed without error 00% 1911 - #10 Short offline Completed without error 00% 1887 - #11 Short offline Completed without error 00% 1863 - #12 Short offline Completed without error 00% 1839 - #13 Short offline Completed without error 00% 1815 - #14 Extended offline Completed without error 00% 1800 - #15 Short offline Completed without error 00% 1791 - #16 Short offline Completed without error 00% 1767 - #17 Short offline Completed without error 00% 1743 - #18 Short offline Completed without error 00% 1719 - #19 Short offline Completed without error 00% 1695 - #20 Short offline Completed without error 00% 1671 - #21 Short offline Completed without error 00% 1647 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.